The sludge separator is used for wastewater treatment, and can be used as a single stage
purification, or as a pre-treatment before the main stage of purification.

The sludge separator is more efficient in retention of particles and sludge flow than conventional 3-chamber sludge separators. The sludge separator is characterized by good hydraulic properties and low particle emissions.

The sludge separator is made of concrete according to the EN 12566-1 standard.

The product is available in two different sizes:
1. 4 m³ approx. The volume of sludge is 2.8 m³
2. 7 m³ approx. The volume of sludge is 6.0 m³
.
Standard sizes with larger volumes can be made to order if required.

Design features:

Abeton sludge separators are designed to withstand loads.
Sludge separator is a cylindrical reinforced concrete structure assembled from standard rings.
Sludge separators are made of concrete, which is a solid and environmentally friendly material. The hole in the lid is located in the center so that drainage and cleaning are simple and efficient.

Complete set for delivery

Sludge separator, available in different sizes. The diameter of the separator varies from DN 2000 – 2400 depending on the load and the number of connected units / persons. The size of the separator is easily selected according to the needs of the customer. The table below shows the size suggestions based on the number of units connected. However, the size should be taken into account in each case, because it is the amount of sludge, which is usually different. As a rule, expect from 250 liters of sludge per person per year for houses with toilets.

The main advantages

1. Reliable, strong and solid construction.

2. No buoyancy.

3. Installation of a concrete slab for fixing
usually not required

4. All concrete rings are sized and designed
so as to withstand the load

5. The precipitated sludge can be used when
production of mineral fertilizers.

The advantage of sludge separators is its hydraulic properties. The design provides
so that the flow of water is distributed over a large area through the distribution plate, and the speed of water
decreases to a minimum. This, together with the vertical flow conditions, results in a very low
particle velocity, which in turn leads to better deposition of sludge particles.

The separator is folded
(Example of 4 m³ separator for 1 household) (3 elements in total):

• 1. Floor slab with hatch.
• 2. Cone with hole for inlet pipe d 110 mm with gasket.
• 3. Wedge-shaped rubber sealing ring.
• 4. A ring with a built-in distribution plate drilled
for an exit of 110 mm with a lining.
• 5. Wedge-shaped rubber sealing ring.
• 6. The lower part.