ABIG PLAST and ABG PLAST round pipes are reinforced concrete non-pressure pipes with polyethylene protective jackets. The pipes are manufactured using vertical forming technology by vibropressing. The polyethylene protective sheath has T-shaped anchors that are monolithically embedded in the pipe walls during its molding, ensuring reliable adhesion to the pipe. The protective liner is made of low-pressure polyethylene (LDPE) and is designed to ensure durability (at least 50 years) and water resistance of sewer pipes when operating under conditions of highly aggressive environment inside the pipes against concrete (reinforced concrete). PNT is resistant to concentrated hydrochloric, carboxylic and hydrofluoric acids, oils, fats, alkalis, salt solutions, resistant to gasoline, low temperatures, plastic and has good impact resistance.

When laying the pipes, the requirements of DSTU EN 1610:2007 Drains and collectors shall be observed. Requirements for design and installation (EN 1610:1997, IDT).

Technical characteristics of polyethylene:

Material – HDPE according to GOST 16338-85, EN ISO 1872-1;
Density – 0.94 g/cm;
Thickness – 3 mm;
Tensile modulus – >= 650 N/mm;
Temperature range – -20°C to +60°C;
Chemical resistance – DIN 8075 sheet 1
Used for laying underground
pipelines transporting by gravity
household liquids, atmospheric wastewater, groundwater
and industrial liquids aggressive to concrete

Marking:

Abig Plast – standing seam pipes with an integrated rubber sealing ring and an inner protective sheath made of polyethylene

Abg Plast is a folded pipe with a wedge-shaped rubber sealing ring and an inner protective sheath made of polyethylene.

Plast pipes are marked with an additional postfix “P”, For example, a standing seam pipe with an integrated rubber seal, DN 1000 mm, 2.4 m long, with a protective sheath is marked Abig Plast Tig-1000×2400-P DSTU EN 1916